There is a 3rd party selling a prewired 3x factory remote start based on the Evo-All so it would seem that the Evo-All can be wired as a stand alone (can-bus) remote start but there are no instructions for this application / US version of the Ford Transit.
See link:
https://www.amazon.com/Start-X-Remote-Starter-2015-2019-Transit/dp/B07PM8ZVNJ
Install Video:
https://d2y5sgsy8bbmb8.cloudfront.net/f71daf72-8800-4c9c-8e09-2963fdbb1b99/default.jobtemplate.mp4.480.mp4
In the installation video (2m37s) the Evo green wire (door status?) is connected to the vehicle Purple/Green described as the vehicle lock wire. Can this connection be explained?
Also, if this is workable what would be the external trigger wire (ground to start/stop)?
For the Evo-All and Thar-For1 T harness would the following be correct?:
Yellow/Black from T harness to [A1] Yellow on 20 Pin connector
Connect [C4] Can Low Grey/Black to Can Low on OBD II
Connect [C3] Can High Grey to Can High on OBD II
Ground Black from T harness
Looking for instructions on any other connection needed ie. lock wire (&diode) and external trigger
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
